Mwongozo wa Maelekezo ya Kipokeaji cha RadioLink R7EH cha 2.4GHz cha Vituo 7

Utangulizi

This manual provides essential information for the proper setup, operation, and maintenance of your RadioLink R7EH 2.4GHz 7-Channel Receiver. Please read this manual thoroughly before using the product to ensure safe and efficient operation.

Figure 1: RadioLink R7EH 2.4GHz 7-Channel Receiver

Bidhaa Imeishaview

The RadioLink R7EH is a compact and reliable 7-channel 2.4GHz receiver designed for use with RadioLink T6EAP, T6EHP, and T7F series transmitters. It utilizes advanced 2.4GHz technology to provide stable and interference-free control for various RC models.

Sifa Muhimu:

7-Channel output for comprehensive control.
2.4GHz frequency hopping spread spectrum (FHSS) technology.
Ubunifu wa kompakt na nyepesi.
Compatible with specific RadioLink transmitters.

Maagizo ya Kuweka

1. Binding the Receiver to the Transmitter:

Ensure both your transmitter (T6EAP, T6EHP, or T7F) and receiver are powered off.
Connect a bind plug (not included, typically comes with the transmitter or flight controller) to the BIND/VCC port on the R7EH receiver.
Power on the receiver. The LED indicator on the receiver should start flashing rapidly, indicating it's in binding mode.
While holding down the bind button on your transmitter (refer to your transmitter's manual for exact location), power on the transmitter.
The LED on the receiver should turn solid, indicating a successful bind.
Release the bind button on the transmitter and power off both the receiver and transmitter.
Ondoa kuziba kuziba kutoka kwa mpokeaji.
Power on the transmitter first, then the receiver. The receiver's LED should be solid, confirming the connection.

2. Connecting Servos and ESC:

Connect your servos, Electronic Speed Controller (ESC), and other components to the corresponding channels on the receiver. Pay close attention to the polarity markings on the receiver ports.

RadioLink R7EH Receiver port details with polarity

Figure 2: Receiver port details showing polarity (Л+-) for correct connection.

Mawimbi (S): Typically the top pin, usually white or yellow wire.
Chanya (+): Middle pin, usually red wire.
Hasi (-): Bottom pin, usually black or brown wire.

Incorrect polarity can damage the receiver or connected components.

Maagizo ya Uendeshaji

Always power on your transmitter first, then your receiver.
After powering on the receiver, ensure the LED indicator is solid, confirming a stable connection to the transmitter.
Test all control surfaces and functions before operating your RC model.
Always power off your receiver first, then your transmitter, to prevent accidental movements or loss of control.

Masafa na Uingilivu:

The 2.4GHz system offers excellent range and interference resistance. However, always perform a range check before flying, especially in new environments. Avoid operating near large metal objects, power lines, or other strong radio frequency sources that could interfere with the signal.

Matengenezo

Weka kipokezi kikiwa safi na bila vumbi, uchafu, na unyevu.
Epuka kuangazia kipokeaji joto kali au jua moja kwa moja kwa muda mrefu.
Regularly inspect all wiring and connections for signs of wear or damage.
Ensure the antenna is not cut, bent sharply, or obstructed, as this can significantly reduce range.

Kutatua matatizo

Tatizo	Sababu inayowezekana	Suluhisho
Receiver LED not solid after binding/power-on	Not bound, out of range, or interference.	Re-perform binding procedure. Ensure transmitter is on and close to receiver. Check for strong interference sources.
No response from servos/ESC	Incorrect wiring, power issue, or faulty component.	Check all connections for correct polarity and secure fit. Verify power supply to receiver and components. Test components individually if possible.
Kupungua kwa masafa au ishara ya vipindi	Damaged antenna, interference, or low transmitter/receiver battery.	Inspect receiver antenna for damage. Avoid operating near known interference sources. Ensure batteries are fully charged.

Vipimo

Kipengele	Maelezo
Mfano	R7EH
Vituo	7 njia
Mzunguko	GHz 2.4
Utangamano	RadioLink T6EAP, T6EHP, T7F Transmitters
Nyenzo	Nyenzo Mchanganyiko
Vipimo (L x W x H)	Sentimita 5 x 3 x 2 cm (takriban.)
Uzito	0.1 kg (100 grams) (approx.)
Umri uliopendekezwa	Miaka 14+

Vidokezo vya Watumiaji

Uwekaji wa Antena: For optimal signal reception, ensure the receiver antenna is positioned away from carbon fiber, metal parts, and other electronics. Try to orient the antenna at a 90-degree angle to the other antenna (if applicable) or away from large conductive surfaces.
Chanzo cha Nguvu: Always use a stable and appropriate power source for your receiver, typically provided by the ESC's BEC or a dedicated UBEC. Verify the voltage is within the receiver's operating range.
Ukaguzi wa Kabla ya Ndege: Before each use, perform a thorough pre-flight check, including range testing and verifying all control surfaces respond correctly and in the right direction.

Udhamini na Msaada

For warranty information and technical support, please contact your original point of purchase or the manufacturer directly. Keep your proof of purchase for any warranty claims.

	Radiolink R7EH-S 7CH 2.4G FHSS Receiver - Setup and Specifications Comprehensive guide to the Radiolink R7EH-S 7-channel 2.4GHz FHSS receiver, covering setup, signal modes (S-BUS, PPM, PWM), fail-safe, and technical specifications for use with Radiolink transmitters.
	Mwongozo wa Maagizo ya RadioLink T16D RadioLink T16D ni kipitisha sauti chenye chaneli 16 chenye uwiano kamili kilichoundwa kwa ajili ya mifumo ya udhibiti wa mbali. Mwongozo huu wa maelekezo hutoa maelezo ya kina kuhusu vipengele vyake, uendeshaji, mipangilio, na matengenezo.
	Kipokezi cha RC cha Radiolink R6DS 2.4GHz: Vipengele, Vipimo, na Mwongozo wa Usanidi Radiolink R6DS ni kipokezi cha RC cha chaneli 6/10 cha 2.4GHz kinachotumia teknolojia ya wigo wa kuenea wa DSSS na FHSS kwa utendaji wa kuaminika wa kuzuia kuingiliwa. Inasaidia matokeo ya mawimbi ya SBUS, PPM, na PWM kwa wakati mmoja, ikitoa muda mfupi wa kusubiri na usahihi wa hali ya juu kwa matumizi ya ndege zisizo na rubani na ndege za modeli. Hii imeisha.view inashughulikia vipengele vyake, hali za uendeshaji, uunganishaji, usakinishaji, na vipimo.
	Mwongozo wa Maelekezo wa RadioLink T12D: Mwongozo wa Kisambazaji cha RC cha Vituo 12 Mwongozo kamili wa maagizo kwa ajili ya kipitisha sauti cha RC cha chaneli 12 cha RadioLink T12D na kipokezi cha R12F. Hushughulikia vipimo, usalama, uendeshaji, mipangilio ya hali ya juu, na telemetri kwa mifumo mbalimbali ya RC.
	RadioLink T8FB(BT) Remote Control System Instruction Manual Comprehensive guide for the RadioLink T8FB(BT) 8-channel remote control system and R8EF receiver, covering setup, safety, app/PC configuration, calibration, and firmware updates for RC aircraft.
	RadioLink T16D Instruction Manual: Comprehensive Guide to Your RC Transmitter Explore the features and operation of the RadioLink T16D 16-channel remote control system. This instruction manual provides detailed guidance on setup, settings, and usage for optimal performance.

RadioLink R7EH